王静毅,童家麟,刘文胜,周飞,闫廷庆,叶学民
WANG Jingyi,TONG Jialin,LIU Wensheng,ZHOU Fei,YAN Tingqing,YE Xuemin

• 1:浙江浙能北仑发电有限公司
• 2:杭州意能电力技术有限公司
• 3:国网浙江省电力有限公司电力科学研究院
• 4:华北电力大学

摘要(Abstract)：

以某两级动叶可调轴流引风机为对象,构建了3种导叶结构:方案一将短导叶改为长导叶,空心导叶不变;方案二将空心导叶改为长导叶,短导叶不变;方案三将所有叶片均改为长叶片。采用Fluent软件模拟了不同方案下的风机气动特性和内流特征,得到优化后的导叶结构,分析其内在机理。研究表明:方案一的风机全压和效率均有下降,方案二在小流量下风机全压小幅上升。方案三的风机性能提升明显,在设计流量下全压和效率分别提升3.8%和1.8%,第一级导叶效率较原结构提升7%;方案三减少了内部流动的掺混程度,内部流动更均匀,叶片总压整体提高约500 Pa。
Three schemes of guide vane configurations were proposed for a two-stage variable-pitch axial draft fan. Scheme 1 changed short guide vanes into long guide vanes, while the hollow guide vanes remained unchanged; scheme 2 changed hollow guide vanes into long guide vanes and kept the original short guide vanes; scheme 3 changed all vanes into long ones. The aerodynamics and internal flow field characteristics were simulated using Fluent to obtain the optimized vane structure, and the internal mechanism was discussed. Simulated results show that the total pressure rise and efficiency of scheme 1 were reduced, the total pressure rise of scheme 2 increased slightly at a small flow rate; the total pressure and efficiency of scheme 3 were improved by 3.8% and 1.8% respectively at the design flow rate, and the efficiency of the first-stage guide vane was increased by 7% in contrast with the original structure; for scheme 3, the mixing of the internal flow was reduced, leading to more uniform internal flow and a total pressure increase of about 500 Pa.

关键词(KeyWords)： 动叶轴流风机;导叶结构;风机性能;内流特征;导叶效率
variable-pitch axial fans;guide vane configuration;fan performance;internal flow feature;guide vane efficiency

Abstract:

Keywords:

基金项目(Foundation): 杭州意能电力技术有限公司科技项目（EPRD2019-07）;; 华北电力大学中央高校基本科研业务费资助项目（13MS98）

作者(Author): 王静毅,童家麟,刘文胜,周飞,闫廷庆,叶学民
WANG Jingyi,TONG Jialin,LIU Wensheng,ZHOU Fei,YAN Tingqing,YE Xuemin

DOI: 10.19585/j.zjdl.202106017

参考文献(References)：

• [1]刘宏凯，叶学民，范福伟，等.长短复合导叶对两级动叶可调轴流风机性能的影响[J].流体机械，2019,47(7):27-33.
• [2]李忠，杨敏官，王晓坤.导叶对轴流泵性能影响的试验[J].排灌机械，2009,27(1):15-18.
• [3]邓向阳，张宏武，黄伟光.低速轴流压气机中前后静叶对动叶顶部区域流动的影响[J].航空学报，2005(5):535-539.
• [4]郭楚，郑源，周大庆，等.导叶叶片数及导叶相对位置对低扬程轴流泵装置性能的影响[J].排灌机械工程学报，2019,37(3):204-210.
• [5]柴立平，黄鑫，邹文鹏，等.导叶数对多级离心泵反转式透平性能的影响[J].中国农村水利水电，2018(5):181-185.
• [6]刘宏凯，叶学民，范福伟，等.导叶数目对两级动叶可调轴流风机叶片静力结构及振动的影响[J].电力科学与工程，2018,34(5):58-64.
• [7]杨从新，齐亚楠，黎义斌，等.核主泵叶轮与导叶叶片数匹配规律的数值优化[J].机械工程学报，2015,51(15):53-60.
• [8]陈得胜，魏萌，闫宏，等.后导叶安装角对动调轴流风机性能影响研究[J].热力发电，2020,49(12):120-127.
• [9]程效锐，张雪莲，吕博儒，等.导叶径向位置对井用潜水泵性能的影响[J].排灌机械工程学报，2019,37(10):848-854.
• [10]郭豹，刘厚林，谈明高，等.导叶周向安装位置对离心泵叶轮径向力的影响[J].排灌机械工程学报，2016,34(3):204-209.
• [11]马希金，崔生磊，周贯五，等.基于CFD的多相泵复合导叶优化设计[J].流体机械，2019,47(2):45-50.
• [12]叶学民，李新颖，李春曦.第一级导叶改进对两级动叶可调轴流风机性能的影响[J].动力工程学报，2014,34(3):228-235.
• [13]SAITO S,SHIBATA M,FUKAE H,OUTA E.Computational cavitation flows at inception and light stages on an axial-flow pump blade and in a cage-guided control valve[J].Journal of Thermal Science,2007(4):337-345.
• [14]JAWORSKI Z,BUJALSKI W,OTOMO N,et al.CFD study of homogenization with dual Rushton turbines—compari son with experimental results:part I:initial studies[J].Chemical Engineering Research and Design,2000,78(3):327-333.
• [15]赵杰.多相泵复合式静叶CFD模拟及流场分析[D].兰州：兰州理工大学，2009.