H2O对尖端放电缺陷下SF6分解产物含量的影响Effect of H2O on the Content of SF6 Decomposition Products under Point Discharge
王绍安,何彦良,邵先军,徐华,沈智伟,孙安邦,张冠军
WANG Shaoan,HE Yanliang,SHAO Xianjun,XU Hua,SHEN Zhiwei,SUN Anbang,ZHANG Guanjun
摘要(Abstract)：
为了研究现场工况GIS(气体绝缘金属封闭开关)运行过程中水分对尖端放电缺陷下SF_6气体分解产物的影响,在252 k V真型GIS故障仿真实验平台基础上构建了SF_6气体分解产物检测系统,通过短时连续局部放电实验,得到GIS腔室内部在尖端放电缺陷下CO,CO_2,CF_4,C_2F_6等SF_6分解产物随微水含量的变化规律。结果表明:在现场工况尖端放电缺陷短时连续监测下,随着放电时间的增加,在高微水情况下φ(CO_2)明显高于低微水情况,而φ(C_2F_6)受水分影响较小,整体增加范围在700×10~(-6)～1 000×10~(-6),可以用这2种产物来表征GIS内部尖端放电缺陷的产生;φ(CO)与φ(CF_4)在不同微水含量条件下,随放电时间的增加波动较大,并无明显变化规律,可以作为尖端放电缺陷的辅助判据。
To study the effect of moisture on SF_6 decomposition products in the operation of GIS in field operating condition,an SF_6 decomposition products detection system was constructed on 252 k V GIS fault simulation and experiment platform.Through short-term continuous partial discharge,it is concluded that SF_6decomposition products such as CO,CO_2,CF_4 and C_2F_6 vary with micro-water under point discharge in GIS chamber.The result shows that under the short-term continuous monitoring of the point discharge defects,φ(CO_2) of high micro-water is more than that of low water content with the increase of discharge time whileφ(C_2F_6) is less affected by moisture,and the overall increase range is 700×10~(-6)～1 000×10~(-6).These two products can characterize the generation of point discharge defects in GIS;under different micro-water contents,φ(CO)andφ(CF_4) fluctuate greatly with discharge time increase,and there is no obvious rule,which can be used as auxiliary judging criteria for point discharge defects.
关键词(KeyWords)：
GIS;尖端放电;六氟化硫;微水含量;分解组分
GIS;point discharge;SF6;micro-water content;decomposition components
基金项目(Foundation): 国网浙江省电力有限公司科技项目(5211DS170012)
作者(Author):
王绍安,何彦良,邵先军,徐华,沈智伟,孙安邦,张冠军
WANG Shaoan,HE Yanliang,SHAO Xianjun,XU Hua,SHEN Zhiwei,SUN Anbang,ZHANG Guanjun
DOI: 10.19585/j.zjdl.201912015
参考文献(References)：
- [1]张晓星,姚尧,唐炬,等.SF6放电分解气体组份分析的现状和发展[J].高电压技术,2008,34(4):664-669.
- [2]邵先军,何文林,王绍安,等.特高压GIS特高频内置传感器有效监测范围现场测试与评估技术研究[J].浙江电力,2017,36(11):16-22.
- [3]TANG J,ZENG F,PAN J,et al.Correlation analysis between formation process of SF6 decomposed components and partial discharge qualities[J].IEEE Transactions on Dielectrics Electrical Insulation,2013,20(3):864-875.
- [4]牛浩,邱悦.气体绝缘组合电器SF6分解产物检测中典型影响因素研究[J].浙江电力,2018,37(8):59-64.
- [5]VAN BRUNT R J.Production rates for oxyfluorides SO_2F_2,SO_2F_2 and SOF_4 in SF6 corona discharges[J].National Bureau of Standards,Caithersburg,1985,90(3):229-253.
- [6]唐炬,胡瑶,张晓星,等.不同气压下SF6的局部放电分解特性[J].高电压技术,2014,40(8):2257-2263.
- [7]唐炬,裘吟君,曾福平,等.局部放电下微水对SF_6分解组分的形成及其影响规律[J].电工技术学报,2012,27(10):13-19.
- [8]唐炬,陈长杰,张晓星,等.微氧对SF_6局部放电分解特征组份的影响[J].高电压技术,2011,37(1):8-14.
- [9]钟理鹏,汲胜昌,刘凯,等.低微水的体积分数对SF_6局部放电及分解特性的影响[J].西安交通大学学报,2016,50(3):112-133.
- [10]齐波,李成榕,骆立实,等.GIS中局部放电与气体分解产物关系的试验[J].高电压技术,2010,36(4):957-963.
- [11]王彩雄,唐志国,常文治,等.气体绝缘组合电器尖端放电发展过程的试验研究[J].电网技术,2011,35(11):157-162.
- [12]VAN BRUNT R J,HERRON J T.Plasma chemical model for decomposition of SF6 in a negative glow corona discharge[J].Physica Scripta,1994,1994(53):9.
- [13]PLUMB I C,RYAN K R.Gas-phase reactions of CF3 and CF_4 with atomic and molecular fluorine:their significance in plasma etching[J].Plasma Chemistry and Plasma Processing,1986,6(1):11-25.
- [14]PLUMB I C,RYAN K R.A model of the chemical processes occurring in CF_4/O_2 discharges used in plasma etching[J].Plasma Chemistry and Plasma Processing,1986,6(3):205-230.
- [15]朱正国,何斌斌,胡冉,等.基于卷积神经网络的开关柜局部放电监测[J].电网与清洁能源,2017,33(3):17-23.